20
TC4-2N6F.rev.07
TO RESET THE MINIMUM AND MAXIMUM
TEMPERATURES (CONTINUED)
Turn the adjustment knob clockwise (or counterclockwise) by
one notch and leave it in this position. The minimum (or
maximum) temperature first appears flashing on the display.
After 10 seconds, the display stops flashing and the room
temperature again appears on the display, indicating that the
reset is completed.
NOTE : To avoid resetting the minimum et maximum temperatures
while recalling them, be sure to return to the room temperature
display within the 10 second delay.
Room Set Point / Temperature Curve
There are two ways to specify the target room temperature:
Adjust the room set point to the desired value and do not activate the
temperature curve. The controller will operate according to this target
room temperature as long as the temperature curve remains deactivated.
Program a temperature curve comprised of six points and activate the
temperature curve. For each of the six points, you must specify a day
number and a room set point for this day number. The controller will
automatically change the target room temperature every hour in a linear
fashion between two consecutive points. When the last point is reached,
the temperature curve becomes deactivated. The controller continues to
operate according to the last room set point until you activate the
temperature curve once again or specify a new room set point. You can
also deactivate the temperature curve before the last point is reached.
crease in speed proportionally to the room temperature. When the room
the controller continues to supply full speed voltage. However, a latch switch
open for natural ventilation.
To Next Page
Loading...
Need help?
General
