4.2 Inline (Inlet) Filter
Check inline (inlet) filter on a weekly basis. The filter cartridge should be cleaned or replaced if it is dirty.
Consult Airtech for replacement elements.
Caution: Depending on the mounting position of the filter, be careful not to allow accumulated
foreign material to fall in the pump suction inlet when removing the filter cartridge. Horizontal
filter installation is recommended to prevent this.
4.3 Maintenance Chart
Check inline inlet filter element/mesh. (this might need to be performed more often if
there are high particulates in the inlet stream)
Check the oil level and protective mesh.
Check Bearings/ Shaft Seals, (this might need to be performed more often if the unit is
operating at ambient temperature that exceeds 68° F (20° C).
Every 1500
operating
hours
Check grease conditions and add additional grease if necessary, especially if the unit is
being operated at an ambient temperature that exceeds 68° F (20° C).
Every 5000
operating
hours
Check the gear oil conditions, and if necessary, change the oils.
To Next Page
Loading...
