2.2 Warning labels and their explanations
Please check and make sure that the following warning labels are clearly visible on your VCX unit:
2.2.1 Read and Understand the manual:
Read and understand this manual before using this machine
2.2.2 Burn Hazard:
Hot surface. Do not touch.
2.2.3 Loud noise Hazard
Ear protection must be worn.
2.2.4 Hazardous Voltage:
Disconnect power before opening. Contact causes severe electrical shock
2.3 Location of the labels
The warning labels shown above should be affixed on the top of the pump’s sound shield, except the
“Hazardous Voltage” label, which should appear on the cover of motor’s terminal box.
3.0 OPERATION
3.1 Start-up
Check rotation of the motor as described in Section 1.4 (Power Requirements). Fill the pump with oil as
described in Section 1.5 (Oil Filling).
Start the pump with the inlet closed. Run the pump for a few minutes and then shut down. Check the
oil level again and make sure the oil level is over 3/4 position of oil sight glass as shown on the label.
Add oil though oil fill port if necessary. Pump oil should only be added when the pump is off.
To Next Page
Loading...