III. Adjusting the Air Flow
The conditioned air is distributed through the ceiling assembly. Slides on the front and rear of the ceiling
assembly can be moved to adjust the air flow to the front and rear.
IV. Hand Held Controller
The remote controller controls the operation of the air conditioner or heat pump with an infrared signal to a
sensor on the ceiling assembly. For the best reception, the remote should be pointing at the ceiling assembly
when changing set points and configuring the air conditioner or heat pump.
Note: Should the remote be lost, the air conditioner or heat pump can be controlled by buttons on the
ceiling assembly.
-3-
To Next Page
Loading...
Need help?
General
