1
INSTALLATION, OPERATION AND
MAINTENANCE INSTRUCTIONS
FOR 47000 SERIES HEAT PUMPS
Selecting an Installation Location
Installing the Roof Top Unit
Installing the Optional Heater
Accessory
Installing Ceiling Assembly
(9600 Series)
Operation and Maintenance
Wall Thermostat Identification and
Operation
Serial Number Nomenclature
Optional Extended Warranty
These instructions are a general guide for installing the 47000 Series Coleman-Mach roof top Heat Pumps. For
specific heat pump details, it will be necessary to refer to ALL printed documents supplied with this unit.
These instructions are for the use of qualified individuals specially trained and experienced in installation of this
type equipment and related system components.
Installation and service personnel are required by some states to be licensed. PERSONS NOT QUALIFIED
SHALL NOT INSTALL NOR SERVICE THIS EQUIPMENT.
NOTE: The words “Shall” or “Must” indicate a requirement which is essential to satisfactory and safe product
performance. The words “Should” or “May” indicate a recommendation or advice which is not essential and not
required but which may be useful or helpful.
WARNING! – SHOCK HAZARD To prevent the possibility of severe personal injury or equipment damage
due to electrical shock, always be sure the electrical power source to the appliance is disconnected.
CAREFULLY FOLLOW ALL INSTRUCTIONS AND WARNINGS IN THIS BOOKLET TO AVOID DAMAGE TO
THE EQUIPMENT, PERSONAL INJURY OR FIRE.
WARNING! Improper installation may damage equipment, can create a hazard and will void the warranty.
The use of components not tested in accordance with these units will void the warranty, may make the
equipment in violation of state codes, may create a hazard and may ruin the equipment.
P/N: 1980-030, Rev 1 08-12-2020
To Next Page
Need help?
General
