To Next PageTo Next Page
Need help?Do you have a question about the Aiwa AD-1800 and is the answer not in the manual?
General| Input Sensitivity | 2.5mV (MM), 150mV (line) |
|---|---|
| Heads | 1 x record/playback, 1 x erase |
| Track System | 4-track, 2-channel stereo |
| Tape Speed | 4.76 cm/s |
| Frequency Response | 20Hz-20kHz |
| Type | Stereo Cassette Deck |
| Motor | DC servo |
Remove six screws to detach the wooden cover.
Pull off control knobs and remove six screws to detach the chassis.
Remove nuts and unsolder capacitor lead to detach Jack-1 circuit board.
Remove three screws to detach the Rec./Pb circuit board.
Pull off the Dolby-NR circuit board for removal.
Remove nut/washer and six screws to detach Jack-2 circuit board.
System using two peak indicators for accurate peak indication.
Uses magnet and Hall IC to replace mechanical contact tape end detectors.
Adjust flywheel vertical position for 0.2-0.3mm thrust.
Measure pinch pressure when pinch roller separates from capstan.
Adjustments for damper and supporting plate assembly.
Adjust tape to avoid contact with tape guide.
Adjust CrO2 lock plate separation for cassette elevating plate.
Required equipment, connection diagrams, and adjustment cautions.
Adjust azimuth screw for maximum output from left/right channels.
Adjust high frequency trimmer for equal outputs at 1kHz and 10kHz.
Adjust playback output trimmer for level meter indication.
Adjust bias current trimmer for 2mV voltage at test point.
Measure frequency response deviation for different tape types.
Adjust peak indicator trimmer for proper red/yellow indicator extinguishing.
Main component locations and connections for Dolby NR adjustment.
Frequency response, S/N, erase efficiency, separation, crosstalk, NR/DNL effectiveness.
List of mechanical components with part numbers and descriptions.
