Power SuppIY
Specifications
OPE/E3ATT
The OPE/BATT indicator lights up while electric current flows
to t17eunit.
Connect the AC cord as illustrated below.
e AC inlet of the unit
Tuner section
Frequency range, antenna — FM: 87.5 -108.0 MHz Rod antenna,
AM: 530-1,710 kHz Ferrite bar antenna
Deck section
Track format — 4 tracks, 2 channels/ Frequency range — Normal tape:
50-12,500 Hz (EIAJ) / Recording system — AC bias/ Erasing system —
Magnet erase / Heads — Recording/playback head (1), Erasure head (1)
CD player section
Disc — Compact disc/ Scanning method — Non-contact optical scanner
(semiconductor laser)
General
Speaker — 80 mm cone type (2) / Output — Headphones jack (stereo
mini-jack) / Power output — 2.5 W + 2.5 W (EIAJ 7 ohms, T.H. D. 10Yo)/
Power requirements — DC 12 V using eight size C (R14) batteries, AC
120 V, 60 Hz/ Power consumption — 15 W / Dimensions — 310 (W) x
156 (H) x 253 (D) mm (121/1x 61/4 x 10 in.) / Weight (excluding
batteries) — 2.6 kg (5 Ibs. 12 oz.)
Accessory — AC cord (1)
. Specifications and external appearance are subject to change without
notice.
COPYRIGHT
Please check the copyright laws relating to recordings from disc,
radio or external tape for the country in which the machine is being
used.
supplied AC*+ ~ to an AC outlet
CAUTION
[Jse oITly the supplied AC cord. Use with other cords may
result in the risk of fire.
open “the lid of the battery compartment on the rear and
insert eight RI 4 (size C) batteries, not supplied, with the 0
and 01 marks correctly aligned. Then close the lid.
To switch from AC power supply to battery power
supply, disconnect the AC cord from the AC inlet.
When to replace the batteries
l-he OPE/BATT indicator becomes dim, the tape speed
slows down, volume decreases, or sound is distorted
during
c)peration.
Notes on batteries
o Do not mix different types of batteries or old batteries with
new ones.
o When the unit is not to be used for a long period, remove
the batteries to prevent needless battery wear.
* Never recharge the batteries, apply heat to them m’ take
them apart.
* Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
ENGLiSH 3
To Next Page
Loading...
