Need help?Do you have a question about the Aiwa Z-M2800 and is the answer not in the manual?
General| Power output | 100W per channel (8 ohms, 1kHz, THD 0.7%) |
|---|---|
| Dimensions | 430 x 150 x 380 mm (W x H x D) |
| Weight | 10.5 kg |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Signal-to-Noise Ratio | 80dB (MM phono), 100dB (line) |
Details tuning range, sensitivity, and antenna specs for the FM tuner.
Details tuning range, sensitivity, and antenna specs for the AM tuner.
Details power output, total harmonic distortion, inputs, and outputs.
Details track format, frequency response, signal-to-noise ratio, and heads.
Details laser, D-A converter, S/N, distortion, and wow/flutter.
Provides warnings and cautions regarding laser beam exposure during maintenance.
Advises on preventing static discharge damage when replacing the optical block.
Illustrates the functional blocks and connections within the tuner section.
Illustrates the functional blocks and connections for the main and front sections.
Illustrates the functional blocks and connections within the CD mechanism.
Details the circuitry for the Main HE section.
Details the circuitry for the Main LH section.
Details the circuitry for the front section.
Details the circuitry for the CD section.
Details adjustments for tuner sections like clock, AM/FM tuning, and tracking.
Details adjustments for tape deck sections like speed, azimuth, and frequency response.
Guides on adjusting focus bias for the optical block.
Guides on adjusting tracking balance for waveform symmetry.
Explains tracking gain adjustment using a servo analyzer.
Addresses problems when the CD test mode cannot be initiated.
Guides troubleshooting for laser, focus, tracking, and sled operations.
To Next Page
