CAUTION: After ACC controls your car to follow and stop, you must confirm that there are no obstacles or
pedestrians and other traffic participants in front of your car when starting and following again.
When ACC is activated, the following conditions must be met at the same time:
●
The gear is in forward position;
●
The brake pedal is not pressed;
●
The electric parking brake is pulled;
●
The seat belt on the driver's side is fastened;
●
All doors of the car are closed;
●
The front compartment lid is closed;
●
The electronic stability program (ESP) is switched on and not activated;
●
HDC is off;
●
AVH is not activated.
ACC tar get speed adjustment
After ACC is activated, the target cruise speed can be increased or decreased by the following methods:
The driver presses down on the accelerator pedal or brake pedal to quickly increase or decrease the
vehicle speed to the desired speed, and short-presses the intelligent driver assistance button
once
to set the current vehicle speed as the target cruise speed;
Under the active state of ACC, after pressing the
or
button for a short time, the target speed
will increase or decrease step by step with the speed value of 5 km/h. After pressing the
or
button for a long time, the target speed will increase or decrease the target speed continuously with the
speed value of 1 km/h each time. After releasing the button, the adjustment and setting of the cruise
target speed will be completed.
ACC following distance adjustment
AIWAYS | 109
To Next Page
Loading...
