accelerator pedal, SCC will return to the active state before entering the override state, slow down to the
target speed or enter the following cruise state according to the latest road conditions.
CAUTION:
●
When the accelerator pedal is stepped on for too long, the SCC will exit to the standby state.
●
When the target vehicle is lost, the front vehicle brakes urgently, the following distance is too short, the
sensor fails, the curve road is too small so that it exceeds the super cruise control, the speed of
cornering is too fast and the vehicle leaves the lane line, the system will prompt the driver to take over
the vehicle actively.
Hands-off alarm
When SCC works, the driver's hands shall always be on the steering wheel. When the system detects that
the driver has hands-off for more than 8s, the system will sound an alarm, and the instrument pop-up
window will prompt "Put your hands back on the steering wheel". If the driver still does not take over the
vehicle in this case, SCC will switch to ACC, the system will sound an alarm, and the instrument pop-up
window will prompt "SCC downgraded take over steering wheel".
Curve control
When a vehicle enters or passes a curve, SCC will control the cruise speed of the vehicle and keep the
vehicle in the lane all the time.
CAUTION:
●
Under different speeds, the curve radius supported by super cruise will change.
●
When the super cruise lateral control is activated, the speed may be lower than the speed when the
lateral control is not activated.
●
Before cornering, if the speed is too high to exceed the maximum speed required for cornering, super
cruise will be downgraded to adaptive cruise mode. When the speed drops to the maximum speed
allowed for cornering, the lateral control of super cruise will be restored and the speed will remain
unchanged.
●
In cornering, super cruise will adjust the speed in real time according to the curve radius.
AIWAYS | 117
To Next Page
Loading...
