●
When the vehicle gear is switched to reverse gear, parking gear or the driving speed is lower than 20km/
h, the BSD function will be automatically turned off.
One of the following conditions may cause failed radar identification and poor BSD performance, including
but not limited to:
●
The radar is misaligned, shielded or covered with soil, ice and snow, metal plates, tapes, labels, leaves
etc.;
●
The radar or its surrounding area is impacted due to a collision or scratch;
●
The radar performance may be affected under extreme weather conditions such as rain, snow, fog ,
haze and so on;
●
False alarms may be given for some metal protective fences, tree lawns and cement walls in a certain
circumstance as the radar is limited to identify targets.
Lane Change Assist (LCA)
The Lane Change Warning is used to monitor the vehicles approaching quickly and overtaking your vehicle
within a range of 80m (long) behind both sides of your vehicle through the millimeter wave radar. When
driving at 20km/h and above, with the turn signal lights turned on, there is a vehicle approaching fast and
overtaking your vehicle in a lane, the warning light on the corresponding exterior rear-view mirror will
flash and give an audible alarm while the instrument panel displays the warning information to warn you
to avoid a collision when changing lanes.
132 | AIWAYS
To Next Page
Loading...
