●
Do not use EPB emergency braking during normal driving. Repeated use of the function may seriously
damage the braking system.
●
Before leaving the vehicle, please ensure that the parking gear has been shifted and the electronic
parking braking (EPB) has been enabled, in order to avoid accidents such as vehicle sliding.
●
When the low-voltage battery of your car is exhausted, the electronic parking function cannot be
activated or released. Please contact AIWAYS at this time for troubleshooting.
Manual emergency braking
In case of emergency during driving, you can pull and hold the EPB switch for emergency braking.
EPB service mode
When the vehicle needs to be moved or the EPB needs to be repaired for rescue, the EPB service mode can
be enabled, and the EPB is always released after the EPB service mode is enabled. You can enable EPB
rescue mode (EPB partially released) and EPB service mode (EPB fully released) through the central
control screen.
PATH: Vehicle Settings - Servicing and Safety
AUTO HOLD
AUTO HOLD can provide braking force in the case of a short stop (such as waiting for the red light), so that
you can keep your car stationary without always stepping on the brake pedal. When starting, you can step
on the accelerator pedal lightly or the brake pedal again to drive your car forward.
Enable AUTO HOLD
After lightly stepping on the brake pedal until the vehicle stops, stepping on the brake pedal again enables
AUTO HOLD.
AUTO HOLD activation requires the following conditions:
●
Driver's door closed
●
The driver's seat belt is fastened
●
The vehicle is in READY mode
78 | AIWAYS
To Next Page
Loading...
