106
Rev 2.1
209 Invalid Pilot type setting L
210 Invalid Postpurge time setting L
211 Invalid Power up with lockout setting L
212 Invalid Pre-ignition time setting L
213 Invalid Prepurge rate setting L
214 Invalid Prepurge time setting L
215 Invalid Purge rate proving setting L
216 Invalid Run flame failure response Setting L
217 Invalid Run stabilization time setting L
218 Invalid Stack limit enable setting L
219 Invalid Stack limit response setting L
220 Unconfigured Delta T limit setpoint setting L
221 Unconfigured DHW high limit setpoint setting L
222 Unconfigured Outlet high limit setpoint setting L
223 Unconfigured Stack limit setpoint setting L
224 Invalid DHW demand source setting L
225 Invalid Flame threshold setting L
226 Invalid Outlet high limit setpoint setting L
227 Invalid DHW high limit setpoint setting L
228 Invalid Stack limit setpoint setting L
229 Invalid Modulation output setting L
230 Invalid CH demand source setting L
231 Invalid Delta T limit delay setting L
232 Invalid Pressure sensor type setting L
233 Invalid IAS closed response setting L
234 Invalid Outlet high limit enable setting L
235 Invalid Outlet connector type setting L
236 Invalid Inlet connector type setting L
237 Invalid DHW connector type setting L
238 Invalid Stack connector type setting L
239 Invalid Header connector type setting L
240 Invalid Outdoor connector type setting L
To Next Page
Loading...
General