Functionality testing
The Ajax security system provides several types of tests that help you make
sure that installation points of devices are selected correctly. Tests do not start
straight away but begin no later than a single hub-detector ping period (36
seconds under default settings of the hub). You can change the ping period of
devices in the Fibra menu of the hub settings.
Fibra Signal Strength Test is available for KeyPad Fibra.
To run a test, in the Ajax app:
Maintenance
Check the functioning of your keypad on a regular basis. This can be done once
or twice a week. Clean the body from dust, cobwebs, and other contaminants as
they emerge, after turning off the keypad to avoid false alarms due to wrong
code attempts. Use a soft dry cloth that is suitable for equipment care.
Do not use substances that contain alcohol, acetone, gasoline, or other active
solvents to clean the keypad. Wipe the touch keypad gently: scratches can
reduce the sensitivity of the keypad.
Technical specications
1. Select the hub if you have several of them or if you are using a PRO app.
2. Go to the Devices menu.
3. Select KeyPad Fibra.
4. Go to Settings .
5. Select FibraSignal Strength Test.
6. Launch and conduct a test.
Learn more
Compliance with standards
To Next Page
Loading...
Need help?
General
