AJEX 240H - 4 Operation Procedure; Overview; Transporting the Unit; Start-Up

4. Operation procedure
4-1. Overview
Refer to pages 17
4-2. Transporting the unit
Refer to pages 19
4-3. Start-up
Refer to pages 20
4-4. Positioning the unit
Refer to pages 20
4-4. Positioning the unit
Refer to pages 20
4-4. Positioning the unit
Refer to pages 20
4-5. Collimating to the object
Refer to pages 21
4-6. Setting the exposure
parameters
Refer to pages 23
4-7. Releasing an exposure
-------------------------------------------------------------
AJEX240H / Operating instructions -16-
AXR-240H-MN01 (E) / Rev. 03
Move AJEX240H
to the location desired
Connect the exposure switch,
Plug the unit in and switch ON.
Position the unit
for the examination
Position the patient or the object
for the examination
Position the cassette
Set the SID,
switch ON the Beam limiting device light,
collimate to the cassette format
Set the kV and mAs
Release the exposure