11
TROUBLESHOOTING
Problem Solution
No sound Increase the volume.
If listening with headphones, make sure they are properly
connected.
Buttons are not
working
Turn off the radio and turn back on after a few seconds.
FM radio: Static
DAB: Intermittent
cut-out
Signal reception is low, adjust the antenna or move the radio to a
stronger signal location.
Re-scan stations.
Sound is distorted The volume is too high; decrease volume.
Station not found The radio signal is too weak, manually tune to find the station.
Display shows ‘no
service’
There is no DAB coverage in your area, or the reception is weak.
Adjust the position of the antenna, or move the radio to a stronger
signal location.
1. Always disconnect the radio from
the power supply and/or remove the
batteries before cleaning.
2. Clean the radio with a soft, damp,
lint free cloth.
3. Do not use abrasives or harsh
cleaners.
WARNING:
DO NOT IMMERSE ANY PART OF THE
APPLIANCE IN WATER
CLEANING & CARE
To Next Page
Loading...
Need help?
General
