8
5. Repeat step 2 and step 3 until you
have preset all the stations from P01
to P10.
6. Press the PRESET button to listen to
preset station P01.
7. Press the PRESET button again
to move on to preset station P02.
Repeat this process as many times
as required to reach other preset
stations.
8. To change the preset stations repeat
the steps above.
9. To restore the default setup
configuration, disconnect or remove
the device’s power source.
MEMORY
• When you first power the radio
on after switching it off, it will
automatically tune to the last
selected radio station.
SETTING THE ALARM
1. In standby mode, press the ALARM
1/VOLUME- button to turn Alarm 1
on or off. When Alarm 1 has been
selected the indicator light will
illuminate.
2. Long press the ALARM 1/VOLUME
button to set the alarm time. The time
will blink on the display to indicate
this function has been selected.
3. Press the BACK/HOUR button to set
the hour and the FORWARD/ MINUTE
button to set the minute.
4. To set Alarm 2, follow the steps as
above, using the ALARM 2/VOLUME +
button.
TURNING OFF THE ALARM
1. In standby mode, press the ALARM 1/
VOLUME- button to turn Alarm 1 off.
2. The indicator light will go off.
3. To turn off the alarm when it sounds,
press the POWER button.
4. To turn off Alarm 2, follow the
steps as above, using the ALARM 2/
VOLUME + button.
CHOOSING AN ALARM SETTING
1. Set the alarm.
2. After setting the time, press the
corresponding ALARM/VOLUME
button again. The display will stop
flashing and return to the radio
frequency screen.
3. Use the BACK/HOUR button and
the FORWARD/MINUTE button to
select between a radio (displayed as
frequency) or buzzer (displayed as
BU) alarm.
4. Press the ALARM/VOLUME button
again to exit.
SNOOZE
To snooze the alarm, press the SNOOZE
button. The alarm will rest for 9 minutes
before sounding again.
SLEEP TIMER
The sleep timer allows you to play audio
for a certain amount of time, before the
radio turns itself off automatically.
USING YOUR APPLIANCE
To Next Page
Loading...
Need help?
General
