9
SETTING THE SLEEP TIMER
1. Press the FUNCTION button to enter
“STANDBY ON” mode.
2. Press the TIME SET/SLEEP SET
button to choose your desired sleep
time. Sleep time is displayed in 10
minute intervals ranging between 10
and 90 minutes.
3. The radio will play for the selected
time and then switch to standby when
the time has elapsed.
4. To turn this function off press the
TIME SET/SLEEP SET button until the
display shows “OFF”.
TO SET THE TIME
1. In standby OFF mode, long press
the TIME SET/ SLEEP SET button to
activate TIME SET mode. The display
will start blinking to indicate this
function has been selected.
2. Press the BACK/HOUR button to set
the hour and the FORWARD/MINUTE
button to set the minutes.
Note: Time is displayed in a 24 hour clock.
PROBLEM POSSIBLE CAUSE SOLUTIONS
No sound/Power. Volume turned down. Adjust the volume using the
volume dial.
Power cord not securely
connected.
Reconnect the power cord.
Backup batteries dead/
incorrectly inserted.
Remove the batteries and
re-insert them into the unit.
If it still does not work, insert
fresh batteries.
No radio signal. Antenna not adjusted/no
frequency.
When listening to FM radio,
ensure the antenna is fully
adjusted.
Use the tuning dial to adjust the
radio frequency.
TROUBLESHOOTING THE APPLIANCE
To Next Page
Loading...
Need help?
General
