Akai ABTS-70

EN - ENGLISH
LED Mode Selection:
• Press button to cycle through different LED modes
• Hold button to turn off top and bottom light
• Hold button to turn off center light
• Double press button to turn on/off side flashing lights
Charging:
1. Use the included USB Charging cable and plug the Micro USB end into the DC 5V port located
at the back of the unit. Plug the other end into a USB powered port.
2. The battery is fully charged in 6.5 hours. (Charging time will be longer if speaker is being
used during charging}
3. The red LED light indicates that the unit is charging. The red LED will turn off when the battery
is fully charged. The charging cable can then be disconnected.
Auxiliary Play Mode:
1. Hold the button to turn on the speaker
2. Connect an audio cable (not supplied) to the 3.5mm audio port at the back of the speaker
3. Connect the other end of the audio cable to the audio source.
4. Speaker will go to auxiliary mode automatically (LED will glow solid white}
Bluetooth Play Mode:
1. When using a Bluetooth enabled audio device, make sure the distance to the speaker is within
10m. Certain environments may affect the working distance.
2. Press and hold the button to turn on the speaker. The unit will give a beeping sound to indicate
it is in Bluetooth mode. The LED will rapidly flash white.
3. Activate Bluetooth on your audio device.
4. Search for new device "ABTS-70” then connect it. No password will be required.
5. Adjust the volume on your audio device to the desired level.
Note: The speaker will automatically power off after 30 mins if is not in use or music not being
played.