Akai AC-410

3) Remove the two retaining screws, then remove the SLED 2) Unhook the LOADING BELT with tweezers.
MOTOR.
Next, extract the plastic gear from the motor shaft and
attach it onto the new motor's shaft.
4) Reassemble in the reverse order.
About the SPINDLE MOTOR:
Replacement of the SPINDLE MOTOR itself is not
recommended, because adjustment of the TURN TABLE
height is quite critical and requires the use of a special jig.
3-1-3. Replacement of the PICK UP BLOCK
1) Remove the TRAVERSE MECHA (refer to section 3-1-1).
2) While pressing the ® stopper upwards, pull the SLIDE LOADING BELT
SHAFT to the right to remove the PICK UP BLOCK, then ;
replace the PICK UP BLOCK. Fig. 3-8
SLED SHAFT 3) Unsolder the lead wires of the LOADING MOTOR with a
@ STOPPER soldering iron.
4) While releasing the LOADING MOTOR's three retaining
hooks, push the motor pully part down with your middle
finger to remove the LOADING MOTOR, then replace it.
GRAY STRIPE
LOADING
PICK UP BLOCK TURN TABLE MOTOR TAR
Fig. 3-6
3) Reassemble in the reverse order,
3-1-4,
Replacement
of
the
LOADING
MOTOR
3:
1)
Slide
the
protruding
part
of
the
GEAR
HOLDER
PART
in
hg.
34
the direction of the arrow, then pull out the TRAY BLOCK. ! :
5) Reassemble in the reverse order. Make sure thatthe wire
with the gray stripe is connected to the motor's 0 rnarked
terminal when soldering.
3-1-5. Removal of the TRAY BLOCK
1) If the TRAY BLOCK is in the “in” position, slice the
protruding part of the GEAR HOLDER PART in thedi rection
of the arrow and pull out the TRAY BLOCK slowly (refer to
Fig. 3-7).
2) In order to disengage the two stoppers, carefuly press
the @ part of the TRAY BLOCK downwards whia pulling
the TRAY BLOCK out as shown in Fig. 3-10.
12