Akai AC-410

STOPPER
TRAY BLOCK
Fig. 3-10
4) Remove the TRAY BLOCK by pulling it out carefully.
5) Reassemble in the reverse order for installation. When
reattaching the TRAY BLOCK to the chassis, carefully
align the guides on both sides of the TRAY BLOCK with
their corresponding rails on the chassis. Also, make sure
that
any
one
of
the
reference
marks
on
the
DISC
HOLDER
TABLE
GEAR
JOINT
DETECT
WORM
aligns
with
the
reference
mark
on
the
LOADING
TRAY.
MOTOR
PART
PCB
GEAR
LOADING
TRAY
DISC
HOLDER
Fig.
3-13
3) Unsolder the leads of the TABLE MOTOR and remove the
TABLE MOTOR. PCB.
{ eo
=j REFERENCE HOLE =» !
]
= Ae \
Wy Y
A REFERENCE MARK
SS piee Dy)
REFERENCE MARK
Fig. 3-11
RED
Next,
move
the
head
of
the
GEAR
HOLDER
PART
in
the
MARK
TABLE
direction
of
the
arrow
before
engaging
the
stoppers
as
shown
;
ee
nee
in
Fig.
3-12.
rig.
S-14
4) Remove the TABLE MOTOR by pulling it out while opening
the TABLE MOTOR retaining hook. Next, remove the
WORM GEAR BLOCK by pulling the GEAR JOINT PART
out and attach it to the new motor as shown in Fig. 3-13.
5) Reassemble in the reverse order.
@ When soldering the TABLE MOTOR PCB onthe TABLE
MOTOR, the TABLE MOTOR’s red mark mustbe visible
through the hole on the TABLE MOTOR PCB,
HEAD OF THE e When attaching the DISC HOLDER on the LOADING
GEAR HOLDER PART TRAY, make sure to place the DISC HOLDER so that
Fig. 3-12 any one of the three reference marks aligns with the
reference mark on the LOADING TRAY (any two
3-1-6. Replacement of the TABLE MOTOR reference holes on the DISC HOLDER align with the
1) Remove the TRAY BLOCK (refer to section 3-1-5). corresponding reference holes on the LOADINGS TRAY
2) Remove the DISC HOLDER retaining screw then remove accordingly). (Refer to Fig. 3-11)
the DISC HOLDER.
13