USING EXTERNAL POWER SOURCE
1. Plug adapter (not included) into 220V
DC power socket and turn on the
adapter switch.
2. Connect adapter (not included) to
the power jack of the unit.
3. Turn on the radio.
Note:
1. When using external power with
adapter (not included), battery power
in the radio will be automatically cut
off.
2. Prior to use of the adapter, please check the polarity of the
external power source to avoid damaging the unit. Polarity of
the external power plug is shown as follows ( Negative pole is
in the middle ).
3. Voltage of external power can be "
" selected in the
range 3V ~ 4.5V.
4. When the adapter is not in use, please turn off the switch. When
using the adapter to supply power to the radio for a long time,
batteries in the unit should be removed.
BATTERY INSTALLATION
1. Open the battery compartment cover
on the back of the radio.
2. Insert 2 AA batteries in the
compartment with correct direction
of the polarity.
3. Close the cover of the compartment.
2
To Next Page
Loading...
Need help?
General
