Using the ATS (AUTO SEEK) function
To perform an automatic search for preset radio stations, use the AUTO
SEEK function (9).
● Short press to search for all stations on the current band and stay on each
station for about 5 seconds. To store the station:
Press the MEMO/LOCK button (10) twice to enter storage mode.•
Press the digit buttons (7) to enter the preset number. Alternatively, use •
the dial (16), or use the SEARCH UP button (15) or the SEARCH
DOWN button (14), to select the preset number.
Press the MEMO/LOCK button (10) twice again to complete the storage •
application.
● Long press to save the stations with good reception automatically and
scan each station for about 5 seconds.
Selecting preset radio stations
● Press the MEMO/LOCK button (10). The indicator (31) ashes on the
display.
● Press the digit buttons (7) to enter the preset number. Alternatively, use
the dial (16) to select the preset number.
● Press the SEARCH UP button (15) to conrm the selection.
Using the SCAN function
● Press the MEMO/LOCK button (10). The indicator (31) ashes on the
display.
● To perform an automatic scan of preset radio stations, use the SCAN
function (9). Press to scan all preset stations in the memory of the current
band and stay on each memory station for about 8 seconds.
● Press any button to exit this function.
FM radio reception
● To switch between Mono and Stereo reception, press the ST/BW button
(6). In the case of a weak FM signal, the audio quality can be improved by
selecting this mode.
MW/SW/LW radio reception
● To switch between wide and narrow band, press the ST/BW button (6).
Wide band: to improve the sound quality of a radio station with a strong -
signal or a local radio station.
Narrow band: to improve the reception of radio stations with a weak signal. -
To Next Page
Loading...
Need help?
General
