8
Operation5.
● To adjust the volume level, turn the VOLUME dial (21) to the required
position.
● To set the display brightness, press the SNOOZE/DIMMER button (6).
● To project the time onto the wall or the ceiling, press the PROJECTION
button (9).
Clock functions5.1
Setting the current time
● Press the SET button (3) once. The display (11) shows the time and
ashes.
● Press the + button (5) or the - button (4) to set the current time. Press and
hold the corresponding button to accelerate the process.
Setting the time format
● Press the SET button (3) twice. The display (11) shows 24Hr and ashes.
● Press the + button (5) or the - button (4) to switch between 12Hr and
24Hr. If 12Hr is selected, the PM indicator (10) will come on.
Setting the snooze duration
● Press the SET button (3) thrice. The snooze indicator (12) comes on.
The display (11) shows 05 and ashes.
● Press the + button (5) or the - button (4) to set the snooze duration
(5 to 60 minutes).
i
During a power failure, or when unplugging the appliance, the time
settings are lost, unless backup batteries are installed.
Setting the alarm time
The alarm time can be set in radio and tone mode. Two time slots are
available (ALM 1 and ALM 2).
● Press the alarm button (7/8). The display (11) shows 6:00 and ashes.
● Press the + button (5) or the - button (4) to set the alarm time. Press and
hold the corresponding button to accelerate the process.
To Next Page
Loading...
Need help?
General
