RADIO OPERATION
1.) Press the STANDBY/ON button to turn the system ‘On’.
3.) Tune to the desired station as follows:
5.) Adjust the VOLUME, DBBS and EQ controls to the desired settings.
6.) When you are finished listening press the STANDBY/ON button to return the system to
the Standby (Off) mode.
4.) If you tuned to an FM Stereo station the ST indicator will
appear in the display. If the FM Stereo reception is
noisy or weak, press the ST/ESP/ID3/FIND button
on the remote control to select the FM Mono mode.
2.) Press the FUNCTION button to select the Tuner function.
An MW or FM frequency will apperar on the display.
Press the TUNER/BAND button to switch
between the MW and FM bands if necessary.
The display lighting comes on and the display briefly
shows “HELLO”.
The display lighting goes off and the display changes from radio frequency to correct time.
Press and hold the SKIP/TUNING or buttons the display begins to move, then
release the buttons.
The Tuner will search up or down the band for the next strong signal
and stop on that station. Reqeat this procedure until the tuner stops on your desired station.
Repeatedly press the SKIP/TUNING or buttons until the display shows the exact
frequency of the desired station. Use the Manual Tuning method to tune to stations that
are not strong enough to be recognized by the Automatic Tuning system.
Manual Tuning
Automatic Tuning
GB 14
To Next Page
Loading...