Akai CS-F110

I. SPECIFICATIONS
TRACK SYSTEM
4 Track 2 Channel Stereo System
TAPE Philips Type Cassette
TAPE SPEED 4.76 cm/s + 1.5% (1-7/8 ips. + 1.5%)
HEADS Erase head x 1
High density metallic head for Recording/Playback x 1
Electronically speed controlled DC motor
Less than 0.04% WRMS, 0.12% (DIN 45500)
90 sec. using a C-60 cassette tape
Normal: 30 to 15,000 Hz + 3 dB (-20 VU)
MOTOR
WOW & FLUTTER
TAPE WINDING TIME
FREQUENCY RESPONSE
CrO,: 30 to 16,000 Hz + 3 dB (-20 VU)
Metal: 30 to 18,000 Hz + 3 dB (~20 VU)
SIGNAL TO NOISE RATIO Normal: Better than 56 dB
CrO,: Better than 58 dB
Metal: Better than 58 dB
(measured via tape with peak recording level)
Dolby NR switch ON: Improves up to 10 dB above 5 kHz
HARMONIC DISTORTION Normal: Less than 0.8%
CrO,: Less than 0.8%
Metal: Less than 0.8%
INPUT MIC: 0.25 mV (input impedance 5.0 kohms)
Required microphone impedance: 600 ohms
Line: 70 mV (input impedance 47 kohms)
OUTPUT Line: 410 mV at 0 VU
Required load impedance: more than 20 kohms
Phone (CS-F12, CS-F210J only): 0.3 mW/8 ohms at 0 VU
Input: 2 mV (input impedance 10 kohms)
Output: 410 mV
Required load impedance: more than 20 kohms
POWER REQUIREMENTS 100V, 50/60 Hz for Japan
120V, 60 Hz for USA and Canada
220V, 50 Hz for Europe except UK
240V, 50 Hz for UK and Australia
110V/120V/220V/240V, 50/60 Hz internally switchable for other
countries.
440(W) x 103(H) x 233(D) mm
(17.3 x 4.1 x 9.2")
4.0 kg (8.8 Ibs)
U/T, JPN: 13W
CSA, AAL: 15W
DIN (CS-F12 only)
DIMENSIONS
WEIGHT
POWER CONSUMPTION
* For improvement purposes, specifications and design are subject to change without notice.
* “Dolby” and the Double D symbol are trademarks of Dolby Laboratories.
(Manufactured under license from Dolby Laboratories).