14: Synchronization
Page 121
ABS
S-M
MIDI Synchronization
The DR16pro can function as a clock master to synchronize external MIDI devices, such as a
sequencer. The DR16pro can use MIDI timecode (MTC), MIDI Machine Control (MMC), and MIDI
Clock (SPP) signals. You can also use MMC software to control the DR16pro externally.
IB-803M MIDI Interface Board
To use MIDI synchronization, you must install the optional IB-803M MIDI interface board. Please
contact your Akai professional dealer for details.
Connection and Setup
Follow the steps below to setup the MIDI synchronization system.
Note:
If you try to set parameters related to MIDI synchronization without an IB-803M board
installed, the message
“NO OPTION”
will appear on the display.
To setup the system:
1) Using MIDI cables, connect the MIDI OUT and MIDI IN terminals of the IB-803M MIDI
interface board on the DR16pro to the appropriate MIDI IN and MIDI OUT terminals on
the external MIDI device.
2) Press the SUB-MENU key.
The indicator in the key will flash and the text “SUB-MENU” will appear on the display.
3) Press the SYNC(SYNC) key.
You will see a display similar to the following:
4) Use the JOG/SHUTTLE control to select a sync mode.
In this case, select “MIDI-SPP”, “MIDI-MTC” or “MIDI-MMC”.
5) Press the STORE/ENT key to store your choice.
SMPTE/EBU
MIDI Clock
MIDI Timecode
MIDI Machine Control
Sync Mode Display
SMPTE - LTC
MIDI - SPP
MIDI - MTC
MIDI - MMC
To Next Page
Loading...