Akai DR16 pro

17: Appendix
Page 142
Digital Audio Format
Simultaneous Recording
Audio Frequency Response
A/D Conversion
D/A Conversion
Dynamic Range
Distortion
Channel Crosstalk
Wow & Flutter
Recording Media
Sampling Rates
Recording Time - 1 GB hard disk
(total recording time at 16 bit rate)
Display
Peak Level Meter
Analog Inputs x8
Analog Outputs x16
or
Analog Master Output (LxR)
Aux Send x2
Digital I/O-A (EIAJ CP-1201)
SYNC Input
AKAINET
EXPANSION
SCSI–A Connector
PHONES
FOOT SW
Appendix
Specifications
16/20/24-bit linear PCM
10 tracks
20 ~ 22 kHz ±1.0 dB (FS @ 48 kHz)
24-bit 128-times oversampling 5th DS modulation
20-bit 8-times oversampling sign magnitude
Greater than 96 dB
Less than 0.02% (1 kHz, full scale –15 dB)
Greater than 90 dB (1 kHz, FS @ 48 kHz)
Immeasurable
Optional internal or external hard disk.
96 kHz, 48 kHz, 44.1 kHz, 44.056 kHz, 32 kHz
FS @ 48 kHz 3 hours 1 minute (approx.)
FS @ 44.1 kHz/44.056 kHz 3 hours 17 minutes (approx.)
FS @ 32 kHz 4 hours 32 minutes (approx.)
Custom FLD - 7-segment Time display, 14-segment Message
display, plus indicators
20-segment FLD bars (Channels 1 ~ 16, or SEND 1/2, BUS L/R,
MASTER L/R)
6.3 ∅mm Stereo phone jack (Balanced/unbalanced connection)
Input gain switch HIGH MID LOW
Nominal input -36 dBu -16 dBu +4 dBu
Maximum input -20 dBu 0 dBu +20 dBu
Impedance 52 kΩ
6.3 ∅mm Stereo phone jack (Balanced/unbalanced connection)
Output gain switch HIGH LOW
Nominal output +4 dBu -10 dBu
Maximum output +18 dBu +4 dBu
Impedance 300 Ω
0 dBu = 0.775 Vrms, Load impedance: 600 Ω balanced,
47 kΩ unbalanced
IN Cannon XLB-3-31 x 1
RCA/phono jack x 1
OUT Cannon XLB-3-32 x 1
RCA/phono jack x 1
BNC connector (Video sync digital wordclock),
Video input: 1 V pp (75 Ω)
BNC connector (50Ω)
1 x 9 pin D-sub male
1 x 50 pin Amphenol
1 x 6.3 ∅mm stereo phone jack (Maximum output 60 mW, Load
impedance 32 Ω)
1 x 6.3 ∅mm phone footswitch jack