6: Projects
Page 55
Loading Project Files
You can load existing project files from any connected hard disk.
To load a project file:
1) Press the SUB-MENU key.
The indicator in the key will flash and the text “SUB-MENU” will appear on the display.
2) Press the 4 (UTILITY) key – numeric keypad.
The message “LOAD PROJ” will appear on the display.
3) Press the STORE/ENT key.
The message “SCSI ID 0” will appear on the display.
4) Rotate the JOG/SHUTTLE control to select the SCSI ID number of the hard disk that
contains the project you want to load.
The SCSI ID numbers range from 0 to 6. The internal hard disk uses SCSI ID 0. External hard
disks can be assigned SCSI ID numbers 1 through 6. See “SCSI IDs” on page 98.
5) Press the STORE/ENT key.
The name of a project located on the specified disk, such as, “DR16 DATA1” will appear
on the display.
6) Rotate the JOG/SHUTTLE control to select the project you want to load.
7) Press the STORE/ENT key.
The message “DONE” appears momentarily on the display.
The DR16pro loads the project.
To Next Page
Loading...