7: Mixer
Page 72
ADAT Digital Output
If you install an optional 8-in/16-out ADAT IB-1616A (or 8-in/8-out ADAT IB-804A) interface board,
you will be able to digitally transfer audio between the DR16pro and an Alesis ADAT machine (or
any other device that includes this interface).
However with the 8-in/8-out ADAT IB-804A, since the Alesis ADAT uses only 8 tracks, you will be
able to transfer only eight audio signals from the DR16pro at any time. In the DR16pro, the ADAT
interface board is fixed to mixer channel outputs 1 through 8. This is fine if you want to transfer
audio from DR16pro mixer channels 1 through 8. If you wish to transfer audio from DR16pro mixer
channels 9 through 16, you must first use the track swap function.
The track swap function enables you to swap mixer channels 1-8 and 9-16. (That is, tracks 1-8 will
be output on channels 9-16, and tracks 9-16 will be output on channels 1-8.)
To Perform the Track Swap Function:
1) Press the SUB-MENU key.
The indicator in the key will flash and the text “SUB-MENU” will appear on the display.
2) Press the MIX(MIXER) key.
You will see a display similar to the following:
ABS
S-M
3) Use the JOG wheel to select “A D A T 1 - 8”.
4) Use the SHUTTLE control to move the cursor to the right field, and rotate the JOG
wheel to select “9 - 16”.
5) Press the STORE/ENT key.
Reset the right field when you wish to digitally transfer audio via channels 1-8.
To Next Page
Loading...