Akai EWI Series - Basic Operation: Saving Voice Data; Saving Pre-programmed Voice Data to Tape

11
Operation
ing
K^^^^f^^j^*^-^":
yoice Data
Voice data has been stored in the 64 memory banks upon shipment
from the factory. When using your EWV2000 for the first time, use
the following procedure to save these voice data onto a cassette tape.
1) Prepare a cassette tape. There is no need to use a Hi-Fi audio
cassette tape — a regular compact tape will do fine.
2) Using a mini-plug cord (available in stores), connect the
EWV2000's TAPE OUT jack to the mike input jack on the
cassette tape recorder.
Rear panel of EWV2000
WC PBOT
OUT M OH
Mini-plug
Cassette tape recorder
3) Turn the EWV2000 power on.
4) Set the cassette tape recorder to the record pause mode.
5) Press the TAPE button on the EWV2000.
The following message will appear on the LCD:
TAPE
TAPE SELCT S. V. L
S = Save
V = Verify
L = Load
6) Start the cassette tape recorder.
7) Press the SAVE button on the EWV2000.
TAPEISAVE ALL
8) Press the SAVE button once again.
tape:save start
The voice data is recorded onto the tape. When all data has been
saved, the LCD will read:
TAPE:SAVE END
9) Set the cassette tape recorder to the record pause mode.
10) Just to be sure, save one more time. Repeat steps 6 through 8.
11) After saving the second time, rewind the tape.
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html