Akai EWI Series - Parameter Copy Functionality; Copying Parameters Between Source 1 and Source 2

41
After all key notes have been assigned program numbers, store these
in the memory banks. These polyphonic chord programs can be
stored for each voice.
The polyphonic chords you have programmed can be saved onto a
cassette tape along with the voice data. However, when saving one
bank at a time, the chord pattern data is not recorded. When saving,
verifying, or loading the data onto or from a cassette tape, always use
the following modes:
NOTE: The assigned data is cleared when the EDIT button is
pressed to set to the PLAY mode and another bank number
is recalled while assigning program numbers to key notes.
Storing in tfie Memory
First turn the MEMORY PROTECT switch on the rear panel to the
OFF position. Next hold in the WRITE button and set the bank
number.
Ex.:
r,
WRITE
Hold In
PROGRAM NO. : 1-
BANK
SOURCE 1
t
PROGRAM NO.
NUMBER
SOURCE2
□
: 1 2
In the example above, the program number is set to bank number 12.
Pre-programmedSample Chord
16 different polyphonic chord pattern samples have been pre
programmed. Use these for example to master the key assigning oper
ation.
Cm
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html