12
Delay
The Delay effect produces an echo of the original signal for a specified period of time.
To add Delay to the Program:
1. Press the FX button.
2. Use the encoder to select Delay, and then press it to select.
3. Use the encoder to select the Delay setting, and then press it to select: Off, Short, Mirror, Long or Custom.
The Custom setting has the following parameters:
• Level: This determines the amount of delay applied (0–100).
• Time: This determines the rate of the delay (0.0–742.9 ms).
• Feedback: This determines the amount of delay signal routed back into the effect (0–100)
Use the encoder to select the parameter, and then press it to move to the next page. Turn the encoder to
change the parameter value, and then press the FX button to move back to the previous page.
4. To exit the FX menu, press the FX button again.
To Next Page
Loading...
Need help?
General
