4
3. Connect
Important: The scenarios below are not mutually exclusive. The EWI Solo can send out audio from its Line Out, from
its Phones jack, and through the built-in speaker all at the same time. The exception is when the EWI Solo is
connected to your computer and powered off (the third scenario in this section): it will send MIDI messages to your
computer but not send any audio. To disable the built-in speaker, use the Global Menu.
To play EWI Solo's audio through an external amplifier, audio interface, etc.:
1. Use a standard 1/4" (6.35 mm) cable to connect the EWI Solo's Line Out to
the line-level input of your keyboard amplifier, audio interface, etc.
Important: The Line Out is a mono output. Use a TS or TRS cable to
connect to a mono input (like those on most keyboard amplifiers, audio
interfaces, etc.).
2. Press the EWI Solo's Power Button to power it on.
To play EWI Solo's audio through headphones:
1. Connect standard 1/8" (3.5 mm) stereo headphones to EWI Solo's Phones
jack.
2. Press the EWI Solo's Power Button to power it on.
To play EWI Solo as a "wired" MIDI controller:
1. Make sure EWI Solo is powered off. If it is not, press and hold the Powe
Button for a full second.
2. Use the included USB cable to connect the EWI Solo's USB port to you
computer.
Items not listed under Introduction > Box Contents in the Quickstart Guide are sold separately.
or
To Next Page
Loading...
Need help?
General
