Akai EWI5000

30
• CC (Continuous Controller): The Interval Button will send a MIDI Continuous
Controller (CC) message. If you select this, press the Trans Button to set additional
message parameters:
o Cn (Controller Number): This is the CC number that will be sent when you
press the Interval Button. Use the Hold Button or Interval Button to set the
CC number (01–127; values over 99 will be shown as the last two digits with a
dot between them). Match this number to the CC number of the parameter you
want to control.
o dU (Data-Up): The value that will be sent with the CC message when you
release the Interval Button. Use the Hold Button or Interval Button to set the
value (00–127; values over 99 will be shown as the last two digits with a dot
between them).
o dP (Data-Press): The value that will be sent with the CC message when you
press the Interval Button. Use the Hold Button or Interval Button to set the
value (00–127; values over 99 will be shown as the last two digits with a dot
between them).
o LA (Latching): This determines if the Interval Button acts as a latching control
or momentary control. If you select this, press and hold the Trans Button to
set additional message parameters:
 OF (Off): When you press and hold the Interval Button, the Data-Press
value will be sent. When you release the Interval Button, the Data-Up
value will be sent.
 on (On): When you press the Interval Button
, the Data-Press value will be
sent. When you press the Interval Button again, the Data-Up value will be
sent.
4. To return to Performance Mode, press the Setup Button until the display is blank.