Akai GX-77 Service Manual

V. VOLTAGE AND CYCLE CONVERSION
POWER TRANS TSO!
VOLTAGE SELECTOR VS |
@|
a
AC CORD
Fig.4 Voltage Conversion (U/T Model Only)
. VOLTAGE CONVERSION
Models for Canada, Europe, USA, UK, Australia and
Japan are not equipped with this facility.
Each machine is preset at the factory according to
destination, but some machines can be set to 110V,
120V or 240V as required.
If voltage change is necessary, this can be accom-
plished as follows:
1) Remove the back board and look for the voltage
selector on the center portion of the machine.
2) Change the position of voltage selector plugs so
that
the
voltage
to
be
used
coincides
with
the
voltage
shown
through
the
opening
of
voltage
selector
plug.
oe
rm
. CYCLE CONVERSION
With
DC
motor,
cycle
conversion
is
not
necessary.
A
ence,
“oO

Akai GX-77 Specifications

General

Track System	4-track, 2-channel stereo
Tape Speed	3 3/4 ips, 7 1/2 ips
Wow and Flutter	0.03% (19 cm/s)
Heads	3
Motors	3
Dimensions	440 x 244 x 358mm
Inputs	Line input (RCA)
Outputs	Line, Headphones