4
Features
Top Panel
1
2
3
4
5
5
6
7
8
9
1. USB Port: Use a standard USB cable to connect this USB port to your computer. The
computer’s USB port provides ample power to LPK25 Wireless, though you may use 3 AA
batteries instead. This connection is also used to send and receive MIDI data to and from
your computer.
2. Power Switch: Use this switch to power LPK25 Wireless on or off. To use USB power, set
it to USB. To use batteries, install 3 AA batteries into the battery compartment underneath
LPK25 Wireless, and set it to Batt.
Note: If you have installed batteries into LPK25 Wireless, you can power it off by setting the
power switch to USB (when it is disconnected from a computer). If you have not installed
batteries into LPK25 Wireless, you can power it off by setting the power switch to Batt.
3. Sustain Pedal Input: Connect an optional 1/4” (6.35 mm) TS sustain pedal to this input.
4. Keyboard: This 25-note keyboard is velocity-sensitive and, in conjunction with the Octave
Down/Up buttons, can access the full range of 127 available MIDI notes (11 octaves).
The Prog Select and Arp On/Off buttons allow some of its keys to access additional
commands. See Operation > Programs and Arpeggiator to learn more.
5. Octave Down/Up (/): Use these buttons to shift the keyboard’s range down or up.
Press both buttons simultaneously to reset the octave shift to “zero.”
6. Prog Select: Hold down this button and press one of the keys on the keyboard labeled
Prog 1, 2, 3 or 4 to load the program of the same number.
7. Arp On/Off: Press this button to enable or disable the internal arpeggiator. The
arpeggiator affects notes being played on the keyboard only, and its rate is based on the
current tempo and time division settings.
Hold this button down press a labeled key on the keyboard to enter new settings for the
arpeggiator. See Operation > Arpeggiator to learn more.
8. Tap Tempo: Tap this button at the desired rate to enter a new tempo for the internal
arpeggiator.
Important: Tap Tempo does not work when LPK25 Wireless is externally synced.
9. Pair: Press this button once to make it available to pair and connect to a nearby Bluetooth
device.
Press this button once more to disconnect it from the currently device. It will automatically
be available to connect to another one.
See Operation > Bluetooth to learn more.
To Next Page
Loading...
Need help?
General
