9
The MPC1000 also has a Patched Phrase function which allows the
phrase sample to follow the tempo of the sequence when it is
dynamically changed. For more information, see the “Dividing a
phrase sample to several Regions” (page 59) section of the
Operator’s Manual.
Saving the data
The data and audio that you input into the MPC1000 will be deleted when you turn off the unit, unless you save it. If you
wish to keep the data, proceed as described in the “Save / Load” section (page 89) or the “Connecting the MPC1000 to your
computer” (page 98) of the Operator's Manual.
Turning off the Autoload function
The MPC1000 is designed like the other MPC series samplers. However, the MPC1000 is set to automatically load the preset
file when you switch on the unit, so that you can start playing with the pads immediately. You can also turn this feature off, if
you would like the MPC1000 not to load the preset file. In this case, when you turn on the unit you have to manually load or
record samples on the MPC1000.
01. Press the [ MODE ] button and then [ PAD 2 ] (LOAD).
When you press the [ MODE ] button, its LED will turn on to let you know that you can select a mode. If you
press [ PAD 2 ] (LOAD) when the LED is lit, the LOAD page will be displayed.
02. In the LOAD from field, press the [ WINDOW ] button.
This brings up the Load Setup window, where you can set the Autoload function.
03. Select OFF in the Autoload field, and press [ F4 ] (CLOSE).
04. Turn off the MPC1000 and then turn it on again.
To Next Page
Loading...
Need help?
General
