8
Operation
CV Setup
The CV Setup menu is used to adjust the parameters for the CV/Gate outputs and Clock
Input/Output.
To enter the CV Setup menu, press and hold Shift and press Bank A/B. Then, use the Encoder to
select and adjust the parameters below. These settings can also be adjusted using the Control
Voltage
section of the Program Editor.
Parameter
Value Range Notes
Src (Source) Keyboard, Key
Sequence, MIDI 01-16,
Pads, Drum Sequencer
Select a channel for the CV to receive on/off
signal transmissions from.
Order
Note order
Low, High, Last Choose the note to be sent via CV when
multiple notes are held down:
Lowest note, Highest note, or Last (newest note
played).
Gate (Gate Mode) Normal, Legato Set how the gate mode will behave when active
and a key has been held down. In Normal mode,
the gate will be retriggered. In Legato mode, the
gate will be held open along with the key.
Mod (Mod
Source)
Key Velocity,
Modwheel Sequence
Velocity
Select the source for the Mod CV output.
Bend (Bend
Range)
01-12 semitones Set the range of the pitch bend to be applied to
the CV pitch output when the pitch wheel is
moved.
IDiv (Clock Input
division)
x4, x2, 1, /1.5, /2, /3,
/4, /6, /8, /12, /24, /48
Set the number of trigger pulses to occur before
the sequencer moves to the next step.
0Div (Clock
Output division)
1, 1/2, 1/4, 1/4t, 1/8,
1/8t, 1/16, 1/16t, 1/32,
1/32t, 24p, 48p
Set the output time division sent by the CV
Clock Output.
To Next Page
Loading...
