9
NAVIGATING EDIT MODE
1. Press the [EDIT] button.
2. To select the controller you wish to edit, simply engage it – this will
prompt the screen to display the properties of the particular controller
(Page 1).
3. If there are multiple properties for the selected controller, turn the
[VALUE] dial to select the property you wish to edit. Press [ENTER] to
view the parameters of the selected property, if available (Page 2).
4. To move between the parameter fields on Page 2, use the [<] and [>]
buttons. To change the values of the fields, turn the [VALUE] dial.
5. When finished editing the controller, press [ENTER] to accept the change
or press [<] to cancel.
FIELD 1
FIELD 2
FIELD 3
FIELD 4
EDIT MODE
Pressing the [EDIT] button calls up
Edit Mode. In this mode, you can
edit the settings of the currently
selected Preset. The settings vary
depending on the controller you are
editing and are described below.
Please note that the changes you
make will only apply to the currently
selected Preset.
You can use the example screenshot on the right to
help you determine where the Page 2 parameters
described on the following page will appear on the
screen.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
