Akai QX-3700

- 7 -
- VOLUME +
Volume mute
Press the MUTE button on the remote control
to instantly lower the volume. Press it again
to resume the normal volume.
Sound adjustment
Press the FUNCTION button repeatedly to display “TREB”, “BASS”,
“L-----R”, Sound Effect and “VOL”.
– When “TREB” is displayed, adjusts the level by rotating the
DOWN VOLUME UP knob on the unit or by pressing the
DOWN or UP button on the remote control.
– When “BASS” is displayed, raises the level for the louder range
by the UP button and lowers the level by the DOWN button.
– When “L-----R” is displayed, press the DOWN/UP button to
balance the left/right side level.
– When Sound Effect is displayed, press the DOWN/UP button to
select different sound effect.
The display will change as the sequence:
Loudness selection
Press the LOUDNESS button on the unit,
“LOUD ON” or “LOUD OFF” will appear
on the display window.
Press the button again to switch “ON” or
“OFF”, meanwhile, the LOUDNESS indicator
on the front panel lights or disappears.
– When “LOUD ON” is displayed , it adds compensation tobass
sounds that are hard to hear at low volume.
– When “LOUD OFF” is selected, the loudness function will be
cancelled.
Tone
When playing the KARAOKE disc, if a song is too high or low for
your range, you can alter the key of the song to suit your voice.
A. Press the “ ” button to lower the tone.
B. Press the “ ” button to raise the tone.
C. Press the “ ” button to resume the tone.
Basic Operations of System
Switch on/off the power
Press the STANDBY/ON button on the
unit or the button on the remote control
to turn on the unit; Press this button again
to turn it off to standby mode.
– The Power button is only a standby switch. To cut power
completely, unplug the power cord from the AC power outlet.
Video out select
According to your television system, you can set the
output system to NTSC or PAL mode by pressing
the PAL/NTST button on the remote control.
NTSC............. for NTSC exclusive TV
PAL ...............for PAL exclusive TV
Input source selection
There are 3 input sources for your selection:
VCD, TUNER, AUX
Press the FUNCTION button, then rotate the DOWN VOLUME
UP knob on the unit or press the DOWN/UP button on the remote
control to select the input source.
The display will change as the sequence:
Setting the clock
You can set the clock in standby mode by using the remote control.
1. Press the ENTER button, the display window will display time
digits, “AM” or “PM” flashes, press the SET button to switch.
And then press the ENTER button, the hour section flashes.
2 Press the SET button to set the hour digits, then press the ENTER
button, the minute section flashes.
3. Press the SET button to set the minute digits, then press the ENTER
button to complete the time setting.
Sound control
Volume
You can adjust the volume by rotating the DOWN VOLUME UP
knob on the unit or the - VOLUME + button on the remote control.
PAL/NTSC
LOUDNESS
DOWN
UPFUNCTION
DOWN
UPFUNCTION
> LIVE <--> JAZZ <--> DISCO <--> HALL <
> VCD <--> TUNER <--> AUX <
MUTE