9
Anti-skating force adjustment
The anti-skating force must be adjusted corresponding to the down force as
follows:
Slip the loop of the anti-skating weight's thread over the 3rd groove of the stub
to set the correct anti-skating force for the factory-fitted cartridge. Feed the
thread through the loop of the wire support.
Stereo System connection
RCA Jacks
· The RCA Jacks of this unit are shared as both the Phone output jacks and the
Line output jacks. They are determined by the Phono/Line Switch.
· When used as a line output, the jacks output analog line-level signals and
could be connected directly with a pair of active speakers or the appropriate
input of your stereo system. When used as a Phono output, they should be
connected to the phono pre-amplifier or the phono input of the stereo
system.
· The Red plug connects with the Right channel and the White plug connects
with the Left channel.
Note:
· If the Phono/Line switch is set at LINE position but RCA jacks connected to the
stereo system’s phono input, the sound might be distorted due to input
overload and could damage your stereo system.
To Next Page
Loading...
