Akai X-1810

8. CARTRIDGE AUTOMATIC STOP
OPERATING PRINCIPLES (See Fig. 14)
When Cartridge Auto Stop/Cont. Play Switch (SW-4) is
set to “Auto Stop”, when the Program Selector comes
to Program “4” position, the voltage passes through
Program Selector and Relay (RLS-1) (1) and voltage is
applied to D5-1 and RLS-1 as shown in Fig. 14, point
“A” is grounded by the Program Selector or Sensing
Tape, RL5-1 is activated, and the motor stops. At the
same time, Solenoid Coil SL5-1 is also activated and
Program Selector is returned to Program 1 position.
Relay RL-1 is held by the voltage supply from P15 (16)
Multi-Jack which passes RL-1.
In order to return to normal mode after Cartridge
Automatic Stop has been effected, the voltage supply to
RL5-1 must be cut. When this is done, SW-4 (Automatic
Stop/Continuous Play Switch) returns to “Cont Play”.
This can also be accomplished by turning the Power’
Switch ON-OFF-ON.
18P MULTI JACK
a
2
wo
D5-I eg
—7,7V 10D! acssv
z dis
y 7)
ha
aa ol R51 = :
Pe) v SL501 7 t
ae
|
3w8
1S
b
S<hKY_
5
es ace
{ ©
: a| be |
=o Ss
ns 88
Be é
z
O% i
{
| |
-27.5V
©
|
PROGRAM
SELECTOR
1
i
|
>
~ in
a ©
= N
if
PROGRAM
SELECTOR SW.
14