Akai X-360D

7) Remove RETAINING SCREWS (marked (a) to (d) ) 8) This picture shows all components removed from
by using a Philips-head screw driver and remove the the case. The upper part houses the mechanism, the
RUBBER FEET (A) and (B). lower part the amplifiers.
9) Carefully disconnect PLUGS (marked (A) to (C) ) 10) Carefully disconnect PLUGS (marked (A) and (B) )
and remove RETAINING SCREWS (marked (a) and and remove SELF TAPPING SCREWS (marked (a)
(b) ). to (d) ) by using a Philips-head screw driver.
11) Remove SELF TAPPING SCREWS (marked (a) to 12) The amplifiers can now be removed.
(d)) by using a Philips-head screw driver, The
“machine may then be separated into two parts.