Need help?Do you have a question about the AKO AKO-16523 and is the answer not in the manual?
Explains the meaning of constant and flashing states on the controller display.
Lists and explains various error and status messages displayed on the unit.
Explains how cold production is regulated by opening/closing the solenoid valve.
Details compressor operation, including pump down and without pump down modes.
Outlines the five possible defrost types based on wizard selection (Inl).
Explains the conditions and methods for initiating a defrost cycle.
Details the criteria for completing a defrost cycle.
Defines the duration for water removal after defrost, with no cold regulation.
Details electric defrosting for a second evaporator, using AUX 2.
Explains defrost by air for a second evaporator, connecting fans in parallel.
Describes static defrost for a second evaporator, with simultaneous start.
Explains how fans are controlled by probe 2 and parameters F0, F1, F2, F3, F4, C22.
Details alarms for exceeding configured maximum or minimum temperatures.
Describes alarms triggered by external digital inputs.
Explains messages for probe faults like open circuit or out of range.
Explains the E2 message for evaporator probe issues during defrost.
Covers delays for start-up, defrost, temperature, external, and door open alarms.
Explains the 'Adt' message for defrost completion by time-out.
Details the 'Pd' message for pump down errors during stop.
Explains the 'LP' message for pump down errors during start-up.
Lists functions like Deactivated, Compressor/crankcase resistor, Light, Virtual control.
Lists functions like Deactivated, Alarm, Light, Virtual control, Door frame resistor.
Explains quick configuration access for most-used parameters using the SET key.
Details how to configure all unit parameters for installation requirements.
Lists and defines parameters for regulation and control functions.
Lists and defines parameters related to defrost operations.
Lists and defines parameters for alarm configuration and behavior.
Covers parameters for power supply, password, MODBUS, and units.
Details configuration for digital inputs and auxiliary relays.
Defines parameters for HACCP alarm temperature and time limits.
Provides read-only information like chosen wizard option and pump down status.
General| Brand | AKO |
|---|---|
| Model | AKO-16523 |
| Category | Temperature Controller |
| Language | English |
To Next Page
