To Next PageTo Next Page
Need help?Do you have a question about the Akron Brass 6047 and is the answer not in the manual?
Instructions for charging the lithium-ion batteries for the wireless remote controller.
Procedure for correctly inserting batteries into the wireless remote controller.
Details on how the controller interacts with Akron Brass wireless receivers and supports different display types.
Description of the physical buttons and their functions on the controller keypad.
Explanation of the status indicators and LEDs on the controller for position and valve status.
Procedure to establish communication between the controller and receiver for proper operation.
Overview of the synchronization process and its importance for system communication.
Step-by-step guide for synchronizing the wireless remote controller with a receiver.
Methods for increasing and decreasing the brightness of the controller's LEDs to optimize battery life.
Procedure to check the current voltage level of the controller's batteries using the LEDs.
How to check the strength of the radio signal between the controller and receiver using LEDs.
Explanation of the controller's power saving modes (Active, Idle, Off) to conserve battery.
Guide to entering and navigating the monitor setup mode using specific key combinations.
List and explanation of error codes displayed by the controller via LEDs for troubleshooting.
Steps to connect the controller to a web browser via WiFi for configuration and updates.
Navigating the web interface for controller configuration, settings, and firmware updates.
Overview of the controller's main web interface page for product ID, firmware, and settings.
Reassigning key positions and configuring the keypad layout via web browser.
Troubleshooting RF communication issues using modem status information.
Configuring interface settings for Monitor 1 and Monitor 2, including ramp times and priority.
Checking which monitor is currently active on the controller.
Understanding the controller's display mode (Enhanced or Legacy) and its features.
The serial number of the synchronized receiver.
The serial number of the monitor.
Setting priority on the CAN bus network for controller and joystick operation.
Adjusting the time for the monitor rotation motor to reach maximum speed.
Adjusting the time for the monitor elevation motor to reach maximum speed.
Assigning a key to function as the AUX key in legacy display mode.
Instructions for updating the firmware of the WiFi module via the web interface.
Instructions for updating the firmware of the host microcontroller via the web interface.
Troubleshooting steps to resolve issues if a firmware update fails.
General| Brand | Akron Brass |
|---|---|
| Model | 6047 |
| Category | Remote Control |
| Language | English |
