AL-KO 901A User Manual (English)

Other manuals for AL-KO 901A

User Manual32 pages

Operating Instructions80 pages

Questions and Answers:

A
Anna SnyderAug 9, 2025
What to do if the load pressure brake does not open on AL-KO Winches?
- T
  Timothy FlemingAug 10, 2025
  If the load pressure brake on your AL-KO Winches doesn't open, it might be due to several reasons. First, ensure the rope is correctly wound, as incorrect winding (crank turned in the wrong direction when lifting) can cause this. Second, the brake could be worn or defective, requiring you to check the brake parts and replace any worn components. Third, the brake pad might be damp or oily, in which case you should clean or change the brake pads. Finally, you can detach any loads, then loosen the brake by gently hitting the crank handle in the "lower" direction with the palm of your hand (when doing this, block off any gears until the crank handle is free, then grease the crank handle).
P
Paul MarshallAug 19, 2025
How to fix a load that does not stop with AL-KO Winches?
- L
  laurahoustonAug 19, 2025
  If the load doesn't stop when using AL-KO Winches, there are a few potential solutions. First, make sure the rope is wound correctly. Second, inspect the brake parts for wear and replace any parts that are worn. Third, try cleaning or changing the brake pads.
N
natalie87Aug 29, 2025
Why won't the load pressure brake close on my AL-KO Winches?
- C
  Christina BanksAug 29, 2025
  If the load pressure brake on your AL-KO Winches doesn't close, it could be because the brake disc mechanism or brake discs are tight. To resolve this, detach any loads, then loosen the brake by gently hitting the crank handle in the "lower" direction with the palm of your hand (when doing this, block off any gears until the crank handle is free, then grease the crank handle).