AL-KO 901 Plus - User Manual

Questions and Answers

C
claytonjaredAug 9, 2025
Why won't the load hold on my AL-KO 901 Plus?
- S
  Shelby HernandezAug 9, 2025
  If the load isn't holding with your AL-KO Winches, it could be due to a few reasons. First, check if the cable or band is wound correctly and fit it properly if it is not. Another possibility is that the brake is worn or faulty, in which case you should inspect the brake parts and replace any that are worn. Finally, the brake disc might be moist or oily; try cleaning or replacing the brake discs.
R
Ryan HigginsAug 15, 2025
How to fix difficult lowering on AL-KO 901 Plus?
- N
  nicholasjohnstonAug 15, 2025
  If you're finding it difficult to lower loads, or even without a load, using your AL-KO Winches, the crank attachment thread might be fixed. Try greasing the crank attachment thread to resolve this.
K
Kim WileyAug 21, 2025
What to do if the load pressure brake does not open on AL-KO Winches?
- J
  jhortonAug 21, 2025
  If the load pressure brake on your AL-KO Winches isn't opening, it could be that the brake disc mechanism or brake discs are braced. Ensure the winch is not under load, then try loosening the brake by gently hitting the crank in the lowering direction with the palm of your hand. You might need to block some gear wheels until the crank loosens. Also, grease the crank attachment thread.
D
Donald GlennAug 27, 2025
What to do if the load does not stop with AL-KO Winches?
- P
  Peter ChambersAug 27, 2025
  If the load doesn't stop when using your AL-KO Winches, it could be due to several reasons. First, check if the rope or strap is incorrectly wound. Ensure it's fitted correctly. Another potential cause is worn or defective brake components, which would require inspection and replacement of worn parts. Lastly, the brake pad might be damp or oily, in which case you should clean or change the brake pads.
C
Craig LambSep 1, 2025
Why is lowering difficult with AL-KO Winches?
- M
  michellewilliamsSep 2, 2025
  If lowering is difficult with or without a load when using AL-KO Winches, the crank handle thread might be stiff. Try greasing the crank handle thread to resolve this issue.