en
Troubleshooting
16 351 - 1201 Plus
Fault Cause Solution
Load pressure brake
does not open
Brake disc mechanism or brake
discs tight
Winch must be without a load! Re-
lease the brake by hitting the crank
handle gently with a hand in the di-
rection "Lower"
➯
If necessary, block the gears un-
til the crank handle is loosened
➯
Grease the crank handle thread
Load pressure brake
does not close
Crank handle not fully wound in du-
ring assembly and tightened with
skt.- screw
See crank handle assembly and
testing information
Lowering difficult with or
without load
Crank handle thread is stiff Grease the crank handle thread.
ADVICE
In the case of faults that are not listed in this table, or faults that you cannot rectify without
assistance, please contact our customer service department.
To Next Page
Loading...
