Why won't the load hold on my AL-KO 1201?
If the load isn't holding with your AL-KO Winches, it could be due to a few reasons. First, check if the cable or band is wound correctly and fit it properly if it is not. Another possibility is that the brake is worn or faulty, in which case you should inspect the brake parts and replace any that are worn. Finally, the brake disc might be moist or oily; try cleaning or replacing the brake discs.
How to fix difficult lowering on AL-KO 1201 Winches?
If you're finding it difficult to lower loads, or even without a load, using your AL-KO Winches, the crank attachment thread might be fixed. Try greasing the crank attachment thread to resolve this.
What to do if the load pressure brake does not open on AL-KO Winches?
If the load pressure brake on your AL-KO Winches isn't opening, it could be that the brake disc mechanism or brake discs are braced. Ensure the winch is not under load, then try loosening the brake by gently hitting the crank in the lowering direction with the palm of your hand. You might need to block some gear wheels until the crank loosens. Also, grease the crank attachment thread.
General| Type | Electric Winch |
|---|---|
| Model | AL-KO 1201 |
| Maximum pulling force | 1200 kg |
| Maximum Load Capacity | 1200 kg |
| Voltage | 12 V |
Warning about brake release due to vibration and not securing loads.
Warning to never stand under suspended loads.
Warning about brake system overheating during extended lowering.
Instructions for safely lowering a load using the winch.
Procedure for lifting or pulling a load with the winch.
Operator responsibility to check cables/bands for wear.
Troubleshooting steps when the load is not held securely.
To Next Page
